MOTION PRO 08-0628 : Motion Pro Pivot Suspension Vise

Designed to make suspension service simple and quick

• Holds shocks and forks securely while you change oil, re-valve, or change seals
• Pivoting head holds parts in any position, with mechanical stops every 45 degrees
• Aluminum Soft Jaw Vise holds cylindrically shaped parts utilizing a 4 point grip system
• Large side holds 39 mm to 69 mm diameter parts
• Small side holds 14 mm to 39 mm diameter parts
• Steel Frame is rigid yet has a small footprint, with 4 pre-drilled holes in the base for secure mounting to a bench
• Movable fluid catch pan with mesh insert, and threaded drain bung

HOW IT WORKS ON FORKS

• Soft Jaw Fork Peg holds fork slider up for removal of dust seal and seal retaining clip
• Repositionable bottom slide bar holds forks compressed while bleeding air (priming cartridge) during reassembly and is an excellent platform for adding, adjusting and taking fork oil level measurements
• Can be used to assist in removing compression valve assembly (use of stock front axle required)

HOW IT WORKS ON SHOCKS

• Holds shock firmly around shock body, shaft or shock reservoir
• Facilitates removal of piston rod and seal head
• Facilitates removal of shock reservoir caps, chamber pistons or bladder
• Holds shock to remove spherical bearings or needle bearings
• Holds shocks for removal of shock spring