HIGHSIDER 280-929HP : HIGHSIDER License Plate Holder Akron-RS Pro

HIGHSIDER AKRON-RS PRO license plate holder incl. license plate light, YAMAHA XSR 125 21-



The HIGHSIDER AKRON-RS PRO license plate holder adapts perfectly to the lines of your bike through its design.



The model-specific bracket of the AKRON-RS PRO allows mounting on the original mounting points of your bike and thus a replacement without further drilling or cutting.

To prevent damage to cables, all sharp-edged feedthroughs are protected by a rubber membrane grommet.



The license plate is made of sheet steel and 2 mm thick. The precise cutting is done by laser. After edging still follows the weather-resistant black powder coating.

This ensures the optimal fit and durability.

Through the stepless adjustment you can bring the plate without drilling in the desired position. To keep the plate in this position, there is an additional locking screw.



The AKRON-RS PRO turn signal brackets are adjustable in width and thus suitable for any type of accessory turn signals. This adjustment option allows you to adjust the position for your turn signals to the most diverse license plates. To allow mounting of the turn signals without separation from the wiring harness, the 8 mm holes are slotted to the side.



Also the position of the reflector you can adjust individually via a slider. Adaptation to the different designs of EU license plates is therefore no problem.



To screw the license plate securely and reduce vibration are included two rubber washers. Another rubber buffer supports the license plate on its underside.



In this PRO version of the AKRON-RS is the very small, milled from high quality aluminum HIGHSIDER license plate light with mounting plate and support arm included. The bracket is adjustable in height and designed to allow mounting in the position required by law.



Details:

- model-specific bracket

- infinitely adjustable turn signal holder

- slotted turn signal holder for easy mounting without cable separation

- infinitely adjustable reflector, E-approved

- suitable for European license plates

- infinitely adjustable tilt angle

- additional screw for optimum position security

- easy fixation without further work steps (eg.e.g. drilling)

- easy mounting of the license plate through slotted holes

- license plate light incl. Holder included

- license plate light, E-tested

- infinitely adjustable license plate light

- many different options for mounting the license plate light



Included with the AKRON-RS PRO are:

- Model-specific bracket with mounting parts

- AKRON-RS license plate holder plate

- Adjustable turn signal holders

- E-tested reflector with adjustable holder

- E-tested license plate light

- Mounting instructions



Notes:

- For the original turn signals is optionally available in the accessories tab a special turn signal holder.

- If side reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced with new ones.



Tip:

If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different designs, are certainly a good alternative.